300 Series

Type 300-C Series Bearing Assemblies were specially developed as an improved design for bearing assemblies used in gypsum wallboard and plywood dryers. The Type 300-C Series Bearing Assemblies allowed the installation of a split type bearing cartridge on the drive side of many conveyor ovens. Once installed on a typical board dryer, bearings could be replaced or rotated without dismantling the surrounding members such as sprockets, drive chain, bearing mounts, rolls, etc. The entire change takes just a few minutes with no tools reducing down time and labor costs. Solid bearing cartridges are also available to maintain design consistency throughout an installation.

Other uses for these patented bearing assemblies include plating equipment, textile finishing equipment, both drying and dying, hot and submerged conveyors and other industrial process equipment where a self-lubricating quick change bearing assembly is required.

Our technical and sales staff will gladly assist you in choosing the design and material that is right for your application.

Select a Frame below then you’ll be directed to your proper Cartridge.
  • • 1515 up to 700F
  • • 2500 up to 1000F
  • • 9800 up to 1100F
  • • 9200 up to 1150F
  • • Self-lubricating and maintenance free
  • • Self-aligning (compensation for shaft deflection and misalignment)
  • • No tools required for bearing replacement
  • • Bearings can be rotated 180° for increased life
  • • Operates dry or submerged
  • • Compact
  • • Inexpensive
  • • Standard bore sizes are 1 ¼ and 30mm
  • • Bore Sizes available up to 1 7/16